Original content by the OOTEE Optics editorial team, drawn from first-hand production line and inspection data. Please credit the source when republishing.
Given limits in expertise and test conditions, the theories, parameters and conclusions here carry no guarantee of absolute accuracy. For technical learning and exchange only - never the sole basis for design, acceptance or selection. Corrections welcome.
Almost every filter datasheet mentions "cut-off depth: OD6" or "OD 4.0". What does it actually mean, and why can two OD6 filters differ twofold in price? This article explains it end to end.
OD stands for Optical Density and is defined as:
OD = −log₁₀(T), where T is out-of-band transmission expressed as a decimal.
In plain numbers:
Each additional OD unit suppresses stray light by another order of magnitude. Going from OD4 to OD6 cuts stray light by a further factor of 100.
Consider fluorescence detection: excitation light is typically 10⁴–10⁶ times stronger than the fluorescence signal. With only OD3 blocking, the residual excitation still swamps the signal and the detector mostly reads noise. Push blocking to OD6 and residual excitation drops to one part per million, letting the fluorescence emerge cleanly.
Recommended values by application:
OD6 is normally guaranteed only within a stated band, e.g. 200–1100 nm. Beyond it — particularly above 1200 nm in the near infrared — blocking can degrade sharply. If your detector is NIR-sensitive, demand "wide blocking" or state "200–1700 nm, OD6" explicitly.
Some vendors quote the average density across the blocking band; others quote the minimum. The two can differ by one to two orders of magnitude. Write "minimum OD ≥ 6 across the blocking range" into your procurement spec.
Large incidence angles shift the blocking edge, and in extreme cases a previously blocked wavelength leaks into the passband. High temperature and humidity also change layer refractive index slightly. Industrial applications should leave margin for real operating conditions.
Blocking band: the wavelength interval that must be suppressed, e.g. "200–1100 nm, OD6". Transition width: the distance from the passband edge to the point where the blocking spec is met. A narrower transition means a steeper edge and better separation of adjacent wavelengths.
OOTEE Optics supplies longpass and shortpass filters with cut-off depths from OD4 to OD6, and can provide measured spectra across the full 200–1700 nm range. Contact us for measured data.
365nm Narrow Bandpass Filter | Ø50mm | T>90%
OT-HBP3659050
365nm Narrow Bandpass Filter; FWHM 10nm; transmission >90%; blocking OD5; size Ø50mm; AOI 0°.
450nm Narrow Bandpass Filter | Ø50mm
OT-HBP4509050
450nm Narrow Bandpass Filter; FWHM 10nm; transmission >90%; blocking OD5; size Ø50mm; AOI 0°.
525nm Narrow Bandpass Filter | Ø50mm
OT-HBP5259050
525nm Narrow Bandpass Filter; FWHM 10nm; transmission >90%; blocking OD5; size Ø50mm; AOI 0°.
Send us your drawing and spectral targets — an engineer replies with a feasibility check and quotation within one business day.